ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Air Bag Disarming and Arming|Page 10903 > < Air Bag Disarming and Arming|Page 10901
Page 18
background image

Special Tool(s)

Special Tool(s)

Deactivation

WARNING:

-

Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.

-

Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in the event
of an accidental deployment.

-

Do not set a live air bag module down with the trim cover face down. This will reduce the risk of injury in the event of an accidental
deployment.

-

After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.

-

Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.

-

The safety belt buckle pretensioner and safety belt retractor pretensioner are pyrotechnic devices. Never probe a pretensioner electrical
connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.

-

The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could
result in injury and possible violation of vehicle safety standards.

-

Never probe the connectors on the side air curtain module. Doing so can result in side air curtain deployment.

-

Never probe the electrical connector on a safety canopy module. Doing so can result in safety canopy deployment.

-

Do not handle, move or change the original horizontal mounting position of the restraints control module (RCM) while the RCM is
connected and the ignition switch is ON. Failure to follow these instructions may result in the inadvertent deployment of the safety
canopy and risk of personal injury.

-

To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:

-

If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental
restraint system (SRS) must be depowered.

-

The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.

-

The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

All vehicles
1. Turn all vehicle accessories OFF.
2. Turn the ignition switch to OFF.

Vehicles built up to 03/2002

Air Bag Disarming and Arming|Page 10903 > < Air Bag Disarming and Arming|Page 10901