ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

A/T - Indicator Lamp ON/DTC's Set|Page 6839 > < Shift Interlock Solenoid|Specifications|Page 6830
Page 1
background image

Technical Service Bulletin # 01-10-7

Date: 010528

A/T - Indicator Lamp ON/DTC's Set

Article No.
01-10-7

05/28/01

^

ELECTRICAL - TRANSMISSION CONTROL
INDICATOR LAMP (TCIL) ILLUMINATED - 
DIAGNOSTIC TROUBLE CODES (DTC) P0713 OR
VARIOUS OTHER TRANSMISSION DTCS - 
VEHICLES BUILT 11/13/2000 THROUGH 3/8/2001

^

TRANSMISSION - 5R55W - TRANSMISSION
CONTROL INDICATOR LAMP (TCIL)
ILLUMINATED - DIAGNOSTIC TROUBLE CODES
(DTC) P0713 OR VARIOUS OTHER TRANSMISSION
DTCS - VEHICLES BUILT 11/13/2000 THROUGH
3/8/2001

FORD:
2002 EXPLORER 

MERCURY: 
2002 MOUNTAINEER

ISSUE
Some 2002 Explorer/Mountaineer vehicles built 11/13/2000 through 3/8/2001 equipped with a 5R55W transmission may exhibit a Transmission Control
Indicator Lamp (TCIL) flashing with various Diagnostic Trouble Codes (DTCs) in self test. DTC P0713 is the code that is most prevalently retrieved.

This may be caused by water intrusion into the transmission solenoid body connector.

ACTION
If a vehicle comes in for this condition, check the transmission solenoid body connector (C199) for signs of water intrusion. If present, replace the
Transmission Wire Harness with part number 1L2Z-7C078-AB. A new harness has been released to prevent this condition. Refer to the following
Service Procedure for details.

OTHER APPLICABLE ARTICLES: NONE 

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage

OPERATION

DESCRIPTION

TIME

011007A

Replace Transmission Wire

1.1 Hr.

Harness

DEALER CODING

CONDITION

BASIC PART NO.

CODE

7C078

X2

OASIS CODES: 206000, 501000, 502000.503000, 504000, 698298

Service Procedure

TRANSMISSION HARNESS REPLACEMENT

1.

Disconnect battery.

2.

Remove transmission connector from Power Train Electronic Controller (PTEC), center pocket.

3.

Remove transmission harness (7C078) from retainers along dash panel.

4.

Ensure the transmission wiring harness is loosened at the rear of the engine.

5.

Attach a length of wire or string to the PTEC connector to assist in pulling/routing of the new transmission wiring harness back up from below the

A/T - Indicator Lamp ON/DTC's Set|Page 6839 > < Shift Interlock Solenoid|Specifications|Page 6830