Explorer 4WD V8-4.6L VIN W (2002)
4.
Replace the original filter with the new service filter 1L2Z-7A098-AC (Figure 1).
5.
Clean the pan.
6.
Reinstall the fluid pan gasket and pan. Tighten the screws in a crisscross pattern to 11 N.m (8 lb-ft).
7.
Add fluid and adjust to the proper level, refer to the workshop manual procedure, Fluid Level Check.
8.
If the noise is still present after the fluid filter has been replaced, follow normal diagnosis for noise concerns using the Diagnosis by Symptom
Charts in the Workshop Manual (Section 307-01).
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION
DESCRIPTION
TIME
011402A
Replace Transmission
1.0 Hr.
Fluid Filter
DEALER CODING
CONDITION
BASIC PART NO.
CODE
7A098
42
OASIS CODES: 501000, 502000, 503000, 504000, 702000