Explorer 4WD V8-4.6L VIN W (2002)
4.
Reinstall the cooler lines into the case and tighten the cooler tube nuts to 30 N.m (22 lb-ft) (Figure 4).
5.
Clean all residual fluid from around the cooler line fittings.
6.
Start vehicle and check for leaks.
7.
Verify fluid level (refer to the appropriate Workshop Manual, Section 307-01) for proper procedure. Add fluid as necessary.
Parts Block
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
OPERATION
DESCRIPTION
TIME
011002A
Install 0-Rings On
1.0 Hr.
Transmission Cooler Lines
(Includes Time To
Disconnect, Clean And
Install 0-Rings)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
7D273
42
OASIS CODES: 501000, 504000