Explorer 4WD V8-4.6L VIN W (2002)
Clutch Slave Cylinder: Service and Repair
Slave Cylinder
Removal and Installation
1. Remove the, transmission.
2. NOTE: Inspect the clutch housing for traces of fluid. If brake fluid is visible, install a new clutch slave cylinder.
Remove the clutch slave cylinder.
1
Remove the bolts.
2
Remove the clutch slave cylinder.
3. Inspect the clutch slave cylinder for the following:
^
Worn or damaged boot.
^
Leaking fluid.
^
Contract and return smoothly.
4. CAUTION: The clutch release hub and bearing is prelubricated and should not be cleaned with solvent. The clutch release hub and bearing are
replaced as an assembly. Do not disassemble for inspection or replacement.
Inspect the clutch release bearing as follows:
^
Rotate the outer race while applying pressure. If the bearing rotation is rough, install a new clutch slave cylinder.
^
Inspect for wear or damage.
^
If wear pattern is continuous (not segmented) and the wear appears to be deep in bearing face, install a new clutch slave cylinder.
5. To install, reverse the removal procedure.
^
Position the clutch slave cylinder to the transmission and install the bolts.
^
Bleed the clutch hydraulic system.