Explorer 4WD V8-4.6L VIN W (2002)
Transfer Case Actuator: Service and Repair
Gearmotor Encoder Assembly
Gearmotor Encoder Assembly
Removal and Installation
1. Press the 4X4 HIGH button on the mode select switch (MSS)
2. Raise and support the vehicle.
3. Disconnect the gearmotor encoder assembly harness connector.
4. Remove the bracket bolt and gearmotor encoder assembly mounting bolts and remove the gearmotor encoder assembly.
5. Remove the grease from the motor adapter and check for any nicks or burrs. If any damage is found, repair or install a new gearmotor encoder
assembly as necessary.
6. To install, reverse the removal procedure.
^
Apply a coat of Multi-Purpose Grease to the gearmotor encoder assembly.