Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
Body / Frame Mount Bushing: Service and Repair
Body Support - Number 1
BODY SUPPORT - NUMBER 1
Material
Material
Removal and Installation
Upper and Lower Insulator
NOTE: Left side shown, right side similar.
1. Remove the door scuff plate.
2. Remove the A-pillar lower trim panel.
1. Remove the pin-type retainer.
2. Remove the A-pillar lower trim panel.
CAUTION: Do not correct a serious misalignment with one jacking operation. Align each section proportionately until the correct
dimensions are obtained.
NOTE: To make sure of accurate measurements, remove all trim from the reference points to expose bare metal.
3. Position back the carpeting and remove the body insulator plug.
