Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
7. Through the glove compartment opening, release the tab and disconnect the passenger air bag module electrical connector.
8. Attach the restraint system diagnostic tool to the vehicle harness side of the passenger air bag module electrical connector.
Vehicles without safety canopies
9. CAUTION: Do not deactivate the safety canopy module circuit by removing the safety canopy bridge resistor from the safety canopy electrical
connector.
If the safety canopy bridge resistor is removed an open circuit fault will be generated by the restraints control module (RCM).
If a restraint system diagnostic tool is installed at the safety canopy electrical connector, a low resistance fault will be generated by the RCM.
Vehicles with safety canopies
10. Remove the RH C-pillar trim panel.
1
Pull out and release the retaining clips.
2
Pull out and release the retainer.
3
Lower the door opening weatherstrip, slide the C-pillar trim panel up, releasing the retainers and remove the C-pillar trim panel.
