Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
22. Position the driver air bag module to the steering wheel.
1
Connect the horn switch electrical connector.
2
CAUTION: The clockspring electrical connectors are unique and cannot be reversed when connected to the driver air bag module.
Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver
air bag module.
Connect the driver air bag module electrical connectors as noted during removal.
3
Position the driver air bag module to the steering wheel.
23. Install the two driver air bag module bolts (one shown).
24. Install the two steering wheel back cover plugs (one shown).
25. Connect the battery ground cable.
26. WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use. Failure
to remove could result in injury and possible violation of vehicle safety standards.
With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS). See: Prove Out Procedure
Vehicles with safety canopies
27. Check the active restraints for correct operation.
Procedures For Repair Operations
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEACTIVATION AND REACTIVATION
