Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
NOTE: Left side of case is shown.
1. Using the scan tool (WDS), monitor the Transmission Fluid Temperature (TFT) using PID TFT.
2. Start the vehicle.
3. NOTE: Engine idle speed is approximately 650 rpm.
While proceeding with this procedure, run the engine until the transmission fluid temperature is between 27°C - 49°C (80°F - 120°F).
4. Move the range selector lever slowly through each gear, stopping in each position and allowing the transmission to engage.
5. Place the range selector lever in the PARK position.
6. With the engine running, position the vehicle on a hoist and set it as close to level as possible.
7. Hold the larger drain plug with a wrench and remove the small (center) fluid level indicating plug using a 3/16-inch Allen key.
8. Install the special tool into the pan.
