Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
Air Bag Control Module: Technician Safety Information
WARNING:
-
Do not handle, move or change the original horizontal mounting position of the restraints control module (RCM) while the RCM is
connected and the ignition switch is ON. Failure to follow these instructions may result in the inadvertent deployment of the safety
canopy and risk of personal injury.
-
The RCM orientation is critical for proper air bag supplemental restraint system (SRS) operation. If a vehicle equipped with an SRS
system has been involved in a collision in which the center tunnel area has been damaged, inspect the mounting and bracket for
deformation. If damaged, the RCM must be replaced whether or not the air bags have deployed. In addition, make sure the area of the
RCM mounting is restored to its original condition.
-
Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. Replace and properly position the
sensor or any other damaged SRS components whether or not the air bag is deployed.
-
The tightening torque of the air bag restraints control module (RCM) retaining nuts is critical for correct system operation.
-
To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or striking
components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood latches.
The side impact sensors (if equipped) are located at or near the base of the B-pillars and C-pillars.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
-
To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the supplemental restraint system
(SRS) deactivation/reactivation procedure.
-
The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.
