Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
supplemental restraint system (SRS) deactivation/reactivation procedure.
Deactivate the supplemental restraint system (SRS).
3. Remove the components in the order indicated in the illustration and table.
INSTALLATION
1. WARNING: The tightening torque of the air bag front impact severity sensor retaining bolts is critical for correct system operation.
NOTE:
-
Make sure the battery negative cable is still disconnected before continuing with the installation portion of this procedure.
-
Make sure the lower radiator support and front impact severity sensor bracket mating surfaces are clean and debris free.
To install, reverse the removal procedure.
2. Connect the battery ground cable.
3. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS). See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure
4. Disconnect the battery ground cable and wait at least one minute.
5. WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.
Reactivate the supplemental restraint system (SRS).
6. WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use. Failure
to remove could result in injury and possible violation of vehicle safety standards.
