Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
6. Clean and inspect the transmission fluid pan and magnet. Clean all mating surfaces.
Refill
1. Install the transmission fluid pan.
1. Position a new transmission fluid pan gasket on the transmission fluid pan.
2. Install and align the transmission fluid pan
^
Loosely install the transmission fluid pan screws.
2. Tighten the transmission fluid pan screws.
^
Tighten the transmission fluid pan screws in a crisscross sequence.
3. If equipped, position the servo heat shield over the servos and clip it to the pan rail.
4. Lower the vehicle.
5. NOTE: When filling a dry transmission and converter, start with a minimum of 3.7 liters (4 quarts).
With the engine running and the transmission at normal operating temperature 66-77°C (150-170°F), check and adjust the transmission fluid level
and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is achieved (fluid should be in the
