Explorer AWD V6-4.0L VIN K Flex Fuel (2003)
Seals and Gaskets: Service and Repair
Drive Pinion Flange and Drive Pinion Seal-Rear Axle
Drive Pinion Flange and Drive Pinion Seal-Rear Axle
Special Tool(s)
Material
1. With the vehicle in NEUTRAL, position on a hoist.
2. Remove the rear wheel and tire assemblies.
3. CAUTION: Remove the rear brake calipers to prevent drag during the drive pinion bearing preload adjustment.
CAUTION: Do not allow the calipers to hang from the brake hoses.
Remove the rear brake caliper and support bracket from the knuckle as an assembly. Wire the caliper and support bracket out of the way.
4. CAUTION: Index-mark the driveshaft flange and rear axle pinion flange to maintain initial balance during installation.
Disconnect and position the driveshaft out of the way.
5. Remove the components in the order indicated in the illustration and table.
