Explorer AWD V8-4.6L (2010)
Sunroof / Moonroof Panel: Service and Repair
Roof Opening Panel Glass
Roof Opening Panel Glass
Removal and Installation
NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system, including:
whenever the roof opening panel motor has been removed from the roof opening panel system, the roof opening panel glass has been removed from the
roof opening panel system, the roof opening panel assembly has been removed from the vehicle, a new roof opening panel motor has been installed, a
new roof opening panel glass has been installed or a new roof opening panel assembly has been installed. For additional information, refer to Roof
Opening Panel Motor Initialization See: Testing and Inspection/Programming and Relearning.
1. Position the roof opening panel to the VENT position.
2. Remove the 4 roof opening panel glass screws.
-
To install, tighten to 4 Nm (35 lb-in).
3. From the outside of the vehicle, remove the roof opening panel glass assembly.
4. To install, reverse the removal procedure.
-
If installing a new roof opening panel glass seal, use care around the corners to make sure of a correct seal to the roof opening panel glass.
-
Align the roof opening panel. For additional information, refer to Roof Opening Panel Alignment See: Adjustments.
-
Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.
