Explorer AWD V8-4.6L (2010)
5. Install the 2 outboard recliner-to-cushion frame bolts.
-
Tighten to 55 Nm (41 lb-ft).
6. Install the second row, 60 percent E-Z entry seat backrest. For additional information, refer to Seat Backrest - Second Row, 60 Percent, E-Z Entry
See: Rear Seat/Seat Backrest - Second Row, 60 Percent, E-Z Entry.
7. Install the second row, 60 percent E-Z entry seat into the vehicle. For additional information, refer to Seat - Second Row, 60/40, E-Z Entry See:
Service and Repair/Rear Seat/Seat - Second Row, 60/40, E-Z Entry.
8. Cycle the backrest down and then back to the upright position. Make sure the inboard and outboard recliners simultaneously and securely
lock in the upright position.
Seat Backrest - Second Row, 40 Percent, Bench
Seat Backrest - Second Row, 40 Percent, Bench
Removal
1. Release the seat backrest J-clip.
2. Remove all the staples holding the backrest trim cover to the backrest support panel.
3. Invert the seat backrest trim cover and foam pad to access the latch cover screws.
4. Remove the 4 screws and the 2 covers. Detach the seat backrest material attachment from both of the latch covers.
5. Remove the 2 backrest support panel lower screws and detach the latch cable. Position the cable out from between the backrest frame and backrest
support panel.
6. Remove the 4 backrest pivot bolts.
7. Remove the 40 percent backrest.
Installation
1. Position the backrest to the latch. The cable is to be routed in front of the spring.
2. NOTE: When installing the backrest to the cushion, make sure the latch cover does not come in contact with the latch cable conduit or end fitting.
The cable is to move freely after assembly.