Explorer AWD V8-4.6L (2010)
All vehicles
10. Position the latch release cable in front of the spring.
11. Roll the backrest trim cover down.
-
For Sport Trac, route the safety belt through the backrest trim cover.
-
Attach the backrest trim cover to backrest foam pad hook-and-loop strips.
12. Attach the backrest trim cover to both of the latch covers. Position the 2 latch covers and install the 4 screws.
13. Position the trim cover and install staples in the backrest support panel.
14. Attach the backrest trim cover J-clip.
15. Position the safety belt anchor and install the bolt.
-
To install, tighten to 121 Nm (89 lb-ft).
Sport Trac vehicles
16. Position the upper latch cover and install the retainers.
17. Install the safety belt guide cover.
All vehicles
18. Install the second row 60 percent seat of the 60/40 bench seat. For additional information, refer to Seat - Second Row, Sport Trac or Seat -
Second Row, Explorer, 60/40 Bench See: Service and Repair/Rear Seat/Seat - Second Row, 60/40 Bench.
Seat Backrest - Second Row, Bucket
Seat Backrest - Second Row, Bucket
Removal and Installation
1. Release all of the seat backrest J-clips. Slightly raise the backrest trim cover.
2. Remove all of the staples in the backrest trim cover.