Explorer AWD V8-4.6L (2010)
NOTE RH side shown, LH side similar
20. Remove and discard both of the head restraint guide sleeves by positioning a 3/16 in. (5 mm) flat- blade screwdriver at a 45° angle to the middle of
the head restraint guide sleeve. Push inward and apply slight downward pressure to release the lock feature. See Figure 12.
NOTE:
The seat backrest trim cover and foam pad are removed for clarity.
NOTE:
Typical head restraint guide sleeve shown, others similar.
21. WARNING: Always carry or place a live air bag module with the air bag and deployment door/trim cover/tear seam pointed away from the body
Do not set a live air bag module down with the deployment door/trim cover/tear seam face down Failure to follow these instructions may result in
serious personal injury in the event of an accidental deployment.
WARNING:
If the seat side air bag cover has been damaged or separated from its mounting, or if the air bag material has been exposed, install a new seat
side air bag module Never try to repair the seat side air bag module Failure to follow these instructions may result in the seat side air bag
deploying incorrectly, which increases the risk of serious personal injury or death in a crash.
NOTICE:
Make sure not to damage the tethered side air bag module bolt cover during removal.
Using a suitable trim tool, open the tethered side air bag module bolt cover and remove the bolt. Remove the side air bag module by carefully
lifting upward and outward from the seat backrest frame. Disconnect the electrical connector.
