Explorer AWD V8-4.6L (2010)
27. Remove the two side air bag module mounting bracket nuts and bracket. Discard the backrest frame. See Figure 17.
Assembly
All Seats
28. Install the side air bag module mounting bracket to the new backrest frame using the two nuts. See Figure 17.
^
Tighten to 8 Nm (70 lb-in).
29. Install the lumbar assembly onto the new backrest frame by squeezing the sides of the lumbar spring clips together.
30. Install the new side air bag module wire harness and the three pin-type retainers onto the new backrest frame as previously noted.
31. Install the backrest foam pad onto the new backrest frame.
32. NOTE: When installing the new upper row of hog rings position the hog rings onto the listing wire first.
NOTE: Make sure the head restraint guide sleeve holes in the backrest foam pad and the trim cover are aligned with the new backrest frame.
Install the backrest trim cover onto the backrest foam pad/new backrest frame.
1. Position the backrest trim cover onto the backrest foam pad/new backrest frame.
2. Using suitable hog ring pliers attach the new upper hog rings to the listing wire.
3. Roll the backrest trim cover down and attach the hook-and-loop strips
