Explorer AWD V8-4.6L (2010)
33. NOTE: When installing the new first row hog rings position the hog rings onto the listing wire first.
Install the new first row hog rings. See Figure 18.
1. Using suitable hog ring pliers.
Install the new first row hog rings onto the listing wire.
2. Attach the hook-and-loop strips and the backrest trim cover lower J-clip.
34. Attach the backrest trim cover flaps to both of the recliners with the new pin-type retainers. See Figure 13.
35. NOTE: Make sure that the side air bag module locator hook engages into the mounting bracket. Install the side air bag module.
1. Connect the side air bag module electrical connector.
2. Position and hook the side air bag module onto the new seat backrest frame.
3. Install the side air bag module bolt. Tighten to 10 Nm (89 lb-ft).
4. Close the tethered side air bag module bolt cover.
36. NOTICE: The RH and LH head restraint guide sleeves are not interchangeable. Failure to correctly install the head restraint guide sleeves may
result in component failure.
