Explorer AWD V8-4.6L (2010)
Use care when disconnecting the seat harness electrical connector. Excessive force on the assurance lever can break the connector mounting
Disconnect the seat harness electrical connectors and remove the seat
1. Slide and disengage the side air bag module electrical connector locking clip, release the tab, and disconnect the side air bag module electrical
connector
2. Release the locking tab and rotate the assurance lever fully to disengage the seat harness electrical connector
3. Disconnect the electrical connector.
Disassembly
9. Position the seat backrest to the full upright position.
10. Position the seat cushion away from the side shield. Remove and discard the manual recliner handle spring clip (See Figure 1). Remove and discard
the manual recliner handle by pulling outward on the handle.
11. If equipped with a power seat, using a suitable trim tool, remove the seat control switch knob See Figure 2.
