Explorer AWD V8-4.6L (2010)
submerge the free end of the tube in a container partially filled with clean, specified brake fluid.
5. Loosen the RH rear bleeder screw. Leave open until clear, bubble-free brake fluid flows, then tighten the RH rear bleeder screw and remove the
rubber hose.
-
Tighten to specifications. For additional information, refer to Specifications.
-
Install the bleeder screw cap.
6. Continue bleeding the system, going in order from the LH rear bleeder screw to the RH front bleeder screw ending with the LH front bleeder
screw.
7. Release the bleeder tank pressure and close the bleeder tank valve. Remove the tank hose from the adapter and remove the adapter from the brake
fluid reservoir.
Manual
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not allow the brake master cylinder to run dry during the bleeding operation. Master cylinder may be damaged if operated
without fluid, resulting in degraded braking performance. Failure to follow this instruction may result in serious personal injury.
NOTICE: Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or
plastic surface, immediately wash the surface with water.
NOTE: The HCU bleeding procedure must be carried out if the HCU or any components upstream of the HCU are installed new.
NOTE: Pressure bleeding the brake system is preferred to manual bleeding.
1. Clean all dirt from the brake master cylinder filler cap and remove the filler cap.
-
Fill the brake master cylinder with clean specified brake fluid.
2. Remove the bleeder screw cap and place a box-end wrench on the RH rear bleeder screw. Attach a rubber drain hose to the RH rear bleeder screw
and submerge the free end of the hose in a container partially filled with clean, specified brake fluid.
