Explorer AWD V8-4.6L (2010)
2. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
3. NOTICE: Do not pry in the brake caliper sight hole to retract the pistons as this can damage the pistons and boots.
NOTICE: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
Remove the 2 brake caliper guide pin bolts and position the brake caliper aside.
-
Support the caliper using mechanic's wire.
4. Remove the brake pads and clips.
-
Discard the clips.
Installation
1. NOTE: One brake disc pad kit contains the pads and pad clips required for both sides.
Install the new brake pad clips and the brake pads.
2. NOTICE: Protect the piston and boots when pushing the caliper piston into the caliper piston bores or damage to components may occur.
Using a C-clamp and a worn brake pad, compress the disc brake caliper pistons into the caliper.
3. Position the brake caliper and install the 2 guide pin bolts.
-
Tighten to 72 Nm (53 lb-ft).
4. Fill the brake master cylinder reservoir with clean specified brake fluid.
5. Install the wheel and tire. For additional information, refer to Wheels and Tires.
-
Apply brakes several times to verify correct brake operation.
