Explorer AWD V8-4.6L (2010)
Parking Brake Cable - Rear, RH
Removal and Installation
1. Release the parking brake cable tension. For additional information, refer to Parking Brake Cable Tension Release See: Procedures.
2. With the vehicle in NEUTRAL position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
3. Remove the 2 wire form bolts.
-
To install, tighten to 15 Nm (133 lb-in).
4. Remove the 2 parking brake cable bracket-to-crossmember bolts.
-
To install, tighten to 15 Nm (133 lb-in).
5. Disconnect the intermediate parking brake cable from the RH rear parking brake cable at the parking brake cable equalizer.
6. Disconnect the front of the RH parking brake cable conduit at the frame bracket.
7. Disconnect the RH parking brake cable from the parking brake lever and remove the parking brake cable.
8. To install, reverse the removal procedure.
-
Test the parking brake system for correct operation.
Parking Brake Cable - Front
Parking Brake Cable - Front
