Explorer AWD V8-4.6L (2010)
-
Position the front camshaft bearing cap.
-
Position the remaining camshaft bearing caps.
-
Install the bolts loosely.
5. Tighten the bolts in the sequence shown.
-
Tighten to 10 Nm (89 lb-in).
6. NOTE: Engine front cover removed from art for clarity.
Remove the Timing Chain Locking Tool.
7. Rotate the crankshaft a half turn counterclockwise until the No. 5 cylinder camshaft exhaust lobe opens the valve and the 2 intake lobes are in the 3
o'clock position as shown.
8. NOTE: Do not allow the valve keepers to fall off of the valve or the valve may drop into the cylinder. If a valve drops into the cylinder, the
cylinder head must be removed. For additional information, refer to Cylinder Head See: Cylinder Head Assembly/Service and Repair/Removal
and Replacement/Cylinder Head - Removal.
NOTE: It may be necessary to push the valve down while compressing the spring.
