Explorer AWD V8-4.6L (2010)
Hydraulic Lash Adjuster
Hydraulic Lash Adjuster
Removal and Installation
1. Remove the camshafts. For additional information, refer to Valve Train Components - Exploded View See: Camshaft/Service and
Repair/Removal and Replacement/Valve Train Components - Exploded View, Camshaft - LH See: Camshaft/Service and Repair/Removal and
Replacement/Camshaft - LH and Camshaft - RH See: Camshaft/Service and Repair/Removal and Replacement/Camshaft - RH.
2. Remove the remaining roller followers from the cylinder head being serviced.
3. NOTICE: If the components are to be reinstalled, they must be installed in their original positions. Mark the components for installation
into their original locations. Failure to follow these instructions may result in engine damage.
Remove the hydraulic lash adjusters that are being serviced.
4. Inspect the hydraulic lash adjusters. For additional information, refer to Engine.
5. NOTE: Lubricate each of the hydraulic lash adjusters with clean engine oil prior to installation.
To install, reverse the removal procedure.
