Explorer AWD V8-4.6L (2010)
6. Remove the PCM bracket nut and the PCM bracket.
7. Remove the suction accumulator stud.
-
To install, tighten to 11 Nm (97 lb-in).
4.6L vehicles
8. Remove the suction accumulator-to-compressor line bracket nut at the condenser-to-evaporator line bracket.
All vehicles
9. Remove the suction accumulator bracket bolt and suction accumulator.
10. Remove the 2 suction accumulator fitting nuts and disconnect the fittings.
-
Discard the O-ring seals.
-
To install, tighten to 8 Nm (71 lb-in).
11. Remove the suction accumulator.
12. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
13. Evacuate, leak test and charge the refrigerant system.