Explorer AWD V8-4.6L (2010)
No
REFER to Steering Column to diagnose the input from the ignition switch.
-------------------------------------------------
AE4 CHECK THE TRANSMISSION GEAR INPUT
-
Enter the following diagnostic mode on the scan tool: PCM or TCM DataLogger.
-
Monitor the PCM (4.0L) or TCM (4.6L) transmission gear status PID while placing the gear selector lever through all positions.
-
Does the PID agree with the gear selection?
Yes
For Explorer or Mountaineer, INSTALL a new SJB. REFER to Body Control Systems. TEST the system for normal operation.
For Explorer Sport Trac, GO to AE5.
No
REFER to Automatic Transmission/Transaxle &/or Transmission Control Systems to diagnose the transmission range input.
-------------------------------------------------
AE5 CHECK THE SJB FOR DRL CONFIGURATION
-
Enter the following diagnostic mode on the scan tool: SJB Module Programming.
-
Check the SJB configuration and make sure the DRL feature is enabled.
-
Is the SJB DRL configuration enabled?
Yes
INSTALL a new SJB. REFER to Body Control Systems. TEST the system for normal operation.
No
ENABLE the DRL configuration. TEST the system for normal operation.
-------------------------------------------------
