Explorer AWD V8-4.6L (2010)
6. Remove the front auxiliary evaporator line fitting nuts and disconnect the fittings.
-
Discard the O-ring seals.
-
To install, tighten to 8 Nm (71 lb-in).
7. Remove the 3 auxiliary line bracket nuts.
-
To install, tighten to 6 Nm (53 lb-in).
8. Remove the 3 auxiliary line bracket bolts.
-
To install, tighten to 6 Nm (53 lb-in).
9. Remove the 6 auxiliary line brackets.
10. Remove the front auxiliary evaporator outlet and inlet lines.
11. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
12. Evacuate, leak test and charge the refrigerant system.
