Explorer AWD V8-4.6L (2010)
No
CONNECT the ACM. GO to Pinpoint Test P. See: Pinpoint Test P: The Global Positioning System Module (GPSM) Does Not Respond To The Scan
Tool
-------------------------------------------------
R8 VERIFY VEHICLE EQUIPMENT - DSM
-
Inspect the vehicle for a DSM.
-
Is the vehicle equipped with a DSM?
Yes
GO to R9.
No
GO to R10.
-------------------------------------------------
R9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE DSM DISABLED
-
Disconnect: SJB Fuse 1 (20A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test M. See: Pinpoint Test M: The Driver Seat Module (DSM) Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to R10.
-------------------------------------------------
R10 VERIFY VEHICLE EQUIPMENT - PRB MODULE
-
Inspect the vehicle for power running boards.
-
Is the vehicle equipped with power running boards?
Yes
GO to R11.
No
GO to R12.
-------------------------------------------------
R11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE PRB MODULE DISABLED
-
Disconnect: BJB Fuse 19 (30A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test N. See: Pinpoint Test N: The Power Running Board Module Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to R12.
