Explorer AWD V8-4.6L (2010)
-
Do all other modules pass the network test?
Yes
CONNECT the RETM. GO to Pinpoint Test L. See: Pinpoint Test L: The Rear Entertainment Module (RETM) Does Not Respond To The Scan Tool
No
GO to R16.
-------------------------------------------------
R16 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISCONNECTED
NOTE: When re-running the network test, the network test application must first be closed or the screen display reverts back to the prior run network
test results.
-
Disconnect: APIM C3342.
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
CONNECT the APIM. GO to Pinpoint Test Q. See: Pinpoint Test Q: The Accessory Protocol Interface Module (APIM) Does Not Respond To The
Scan Tool
No
CONNECT the APIM. GO to Pinpoint Test K. See: Pinpoint Test K: The Satellite Digital Audio Receiver System (SDARS) Module Does Not Respond
To The Scan Tool
-------------------------------------------------
R17 VERIFY VEHICLE EQUIPMENT - PAM
-
Inspect the vehicle for a PAM.
-
Is the vehicle equipped with a PAM?
Yes
GO to R18.
No
GO to R19.
-------------------------------------------------
R18 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE PAM DISABLED
-
Disconnect: SJB Fuse 18 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. GO to Pinpoint Test O. See: Pinpoint Test O: The Parking Aid Module (PAM) Does Not Respond To The Scan Tool
No
INSTALL the removed fuse. GO to R19.
-------------------------------------------------
R19 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must first be closed or the screen display reverts back to the prior run network
test results.
