ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2852 > < Initial Inspection and Diagnostic Overview|Page 2850
Page 63
background image

-

Inspect the vehicle for an HVAC module.

-

Is the vehicle equipped with an HVAC module?

Yes

GO to S33.

No

GO to S34.

-------------------------------------------------
S33 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE HVAC MODULE
DISCONNECTED

-

Disconnect: HVAC Module C228a.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to S51.

No

GO to S34.

-------------------------------------------------
S34 VERIFY VEHICLE EQUIPMENT - RETM

-

Inspect the vehicle for a RETM.

-

Is the vehicle equipped with an RETM?

Yes

GO to S35.

No

GO to S36.

-------------------------------------------------
S35 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE RETM DISCONNECTED

-

Disconnect: RETM C9029.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

Initial Inspection and Diagnostic Overview|Page 2852 > < Initial Inspection and Diagnostic Overview|Page 2850