Explorer AWD V8-4.6L (2010)
the ETB.
2. Monitor the temperature of the top TP sensor bolt ear on the ETB with a suitable temperature measuring device, such as a digital temperature
laser or infrared thermometer, while heating the ETB.
3. Using hand tools, quickly remove the bolt farthest from the heat source first and discard.
4. Using hand tools, remove the remaining bolt and discard.
5. Remove and discard the TP sensor.
Installation
All vehicles
1. NOTE: Do not use power tools.
Install the new TP sensor.
-
Using hand tools, install the 2 new bolts.
-
Tighten to 3 Nm (27 lb-in).
Vehicles equipped with a 4.6L (3V) engine
2. Install a new O-ring seal and position the heated PCV fitting and install the 2 bolts.
3. Connect the heated PCV fitting electrical connector.
4. Connect the PCV hose to the heated PCV fitting.
