Explorer AWD V8-4.6L (2010)
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the accessory drive belt. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
3. Disconnect the A/C compressor coil electrical connector.
4. Detach the battery cable retainer from the A/C compressor stud bolts.
5. Remove the nut and detach the A/C tube bracket.
-
To install, tighten to 10 Nm (89 lb-in).
6. Remove the nuts, the stud bolt and position the A/C compressor aside.
-
To install, tighten to 25 Nm (18 lb-ft).
7. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
8. Remove the bolt and the CKP sensor.
-
To install, tighten to 10 Nm (89 lb-in).
9. To install, reverse the removal procedure.
