Explorer AWD V8-4.6L (2010)
4. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly installed onto the manual control
lever. Pull back on the selector lever cable to make sure that the selector cable end is correctly installed onto the manual control lever.
Install the selector lever cable end onto the manual control lever, selector lever cable bracket and selector lever cable bracket screws.
-
Tighten to 40 Nm (30 lb-ft).
5. NOTE: If the selector lever cable shield is loose on the selector lever cable, install a new selector lever cable shield.
Install the selector lever cable shield.
4WD vehicles
6. Install the front driveshaft in the vehicle.
7. Connect the front driveshaft to the transfer case. Install the CV joint washers and CV joint bolts.
-
Tighten to 30 Nm (22 lb-ft).
8. Connect the front driveshaft to the front differential. Install the U-joint straps and U-joint strap bolts.
-
Tighten to 19 Nm (168 lb-in).
