Explorer AWD V8-4.6L (2010)
Body Control Module: Service and Repair
Driver Seat Module (DSM)
Driver Seat Module (DSM)
Removal and Installation
NOTICE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the removal of the module, it is necessary to upload the module configuration information to the scan tool. This information must be
downloaded into the new Driver Seat Module (DSM) after installation. For additional information, refer to Information Bus.
1. NOTE: This step is necessary only if the DSM is being replaced.
Upload the module configuration information from the DSM. For additional information, refer to Information Bus.
2. Remove the driver seat. For additional information, refer to Seats.
3. Remove the 2 DSM screws.
4. Disconnect the electrical connectors and remove the DSM.
5. NOTE: When a new DSM is installed, it is necessary to download the module configuration information from the scan tool into the new DSM.
