Explorer AWD V8-4.6L (2010)
Impact Sensor: Service and Repair
Side Impact Sensor - C-Pillar
Side Impact Sensor - C-Pillar, Explorer, Mountaineer
NOTE: RH shown, LH similar.
WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas
for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed
whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: The LH and RH C-pillar mounted side impact sensors are not interchangeable.
1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag
Systems/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General
Procedures.
2. Remove the rear door scuff plate.
3. Remove the bolt and safety belt anchor.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Detach the upper C-pillar trim panel and position aside.
5. Position aside the quarter trim panel.
-
Pull out on the quarter trim panel at the C-pillar to release the retaining clips and access the C-pillar side impact sensor.
6. Disconnect the electrical connector.
7. NOTE: Note the position of the sensor and bracket locating tab for installation.
