Explorer AWD V8-4.6L (2010)
Installation
All vehicles
1. Inspect the O-ring seal for damage. Install a new O-ring seal if damaged. Lubricate the O-ring seal with petroleum jelly to prevent damage to the
O-ring seal.
1. Install the intermediate shaft speed sensor into the transmission.
2. Tighten the intermediate shaft speed sensor screw.
-
Tighten to 14 Nm (124 lb-in).
2. Connect the intermediate shaft speed sensor connector.
3. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly installed onto the manual control
lever. Pull back on the selector lever cable to make sure that the selector cable end is correctly installed onto the manual control lever.
Install the selector lever cable end onto the manual control lever, selector lever cable bracket and selector lever cable bracket screws.
-
Tighten to 40 Nm (30 lb-ft).
4. NOTE: If the selector lever cable shield is loose on the selector lever cable, install a new selector lever cable shield.
Install the selector lever cable shield.
