Explorer AWD V8-4.6L (2010)
Cross-Member: Service and Repair
Transmission Support Crossmember
Transmission Support Crossmember
NOTE: Explorer/Mountaineer shown, Explorer Sport Trac similar.
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the 4 transfer case skid plate bolts and remove the transfer case skid plate.
-
To install, tighten to 15 Nm (133 lb-in).
3. NOTE: Explorer/Mountaineer shown, Explorer Sport Trac similar.
Remove the heat shield bolt from the RH heat shield.
-
To install, tighten to 18 Nm (159 lb-in).
4. Remove the heat shield bolt from the LH heat shield.
-
To install, tighten to 18 Nm (159 lb-in).