Explorer AWD V8-4.6L (2010)
Installation
1. NOTE: Make sure the extension housing seal is correctly installed onto the Extension Housing Seal Installer and the garter spring is in the correct
position.
Using the Extension Housing Seal Installer, install the extension housing seal.
2. Install the transfer case assembly. For additional information, refer to Transfer Case.
3. Carry out the transmission fluid level check. For additional information, refer to Transmission Fluid Level Check See: Service and
Repair/Procedures/5R55S/Transmission Fluid Level Check.
Extension Housing Gasket
Extension Housing Gasket - Four Wheel Drive (4WD)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Support the transmission with a suitable jack.
3. Remove the transfer case. For additional information, refer to Transfer Case.