Explorer AWD V8-4.6L (2010)
4. NOTE: The park pawl, park pawl return spring and park pawl shaft may fall out during removal of the extension housing.
Remove the extension housing.
5. Remove and discard the extension housing gasket.
Installation
1. Clean the extension housing and install new extension housing gasket. Make sure that the park pawl is installed correctly.
2. NOTE: Verify the park lever actuating rod is correctly seated into the case park rod guide cup.
Install the extension housing and the extension housing screws.
-
Tighten to 30 Nm (22 lb-ft).
3. Install the transfer case. For additional information, refer to Transfer Case.
4. Remove the transmission support jack.
5. Carry out the transmission fluid level check. For additional information, refer to Transmission Fluid Level Check See: Service and
Repair/Procedures/5R55S/Transmission Fluid Level Check.