Explorer AWD V8-4.6L (2010)
Transmission Position Switch/Sensor: Adjustments
Transmission Range (TR) Sensor Adjustment
Adjust
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the selector lever cable shield by prying on the side of the shield closest to the boot, then sliding the shield away from the boot.
3. Move the rubber boot back to gain access to the Transmission Range (TR) sensor connector.
4. Disconnect the TR sensor connector.
5. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
Remove the selector lever cable end from the manual control lever.
6. Remove the manual control lever nut and the manual control lever.