Explorer AWD V8-4.6L (2010)
Windshield Washer Reservoir: Service and Repair
Washer Reservoir
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the Air Cleaner (ACL) assembly. For additional information, refer to Fuel Delivery and Air Induction.
3. Remove the RH front fender splash shield.
4. Disconnect the windshield washer pump electrical connector.
5. Disconnect the windshield washer solvent level electrical connector.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In
the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data
Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE: If necessary, drain the windshield washer reservoir after removal.
6. Disconnect the windshield washer reservoir hoses.
7. Remove the top bolt.
-
To install, tighten to 5 Nm (44 lb-in).
