Explorer FWD L4-2.0L Turbo (2011)
11. NOTE:
-
The hex-holding feature can be used to prevent turning of the stud while installing the nuts.
-
RH shown, LH similar.
Install new tie-rod end nuts.
-
Tighten to 150 Nm (111 lb-ft).
12. Install the new stabilizer bar bracket-to-front subframe bolts.
-
Tighten to 55 Nm (41 lb-ft).
13. Install the engine exhaust Y-pipe.
14. Position the RH engine splash shield and install the 2 lower pin-type retainers.
15. Install the underbody shield and the 4 retainers.
16. If equipped, Install the underbody air duct and the 3 retainers.
