Explorer FWD L4-2.0L Turbo (2011)
12. Adjust the parking brake cable tension. REFER to Parking Brake Cable Tension Release.
13. Connect the subframe assembly main electrical connector.
14. Install the 2 new rear shock absorber lower bolts.
-
Tighten to 175 Nm (129 lb-ft).
15. Using a suitable jackstand, support the lower control arm.
16. Position the sway bar and install the 2 new sway bar link upper nuts.
-
Tighten to 150 Nm (111 lb-ft).
17. Remove the jackstand from the lower control arm.
18. NOTE: If equipped, align the driveshaft using the index-mark made during removal.
If equipped, position the driveshaft and install the 6 new driveshaft bolts.
-
Tighten to 25 Nm (18 lb-ft).
19. Install the muffler and tail pipe.
20. Install the rear wheels.
