Explorer FWD L4-2.0L Turbo (2011)
Installation
1. NOTE:
-
There are 2 RDU front bushings in the rear subframe. This procedure shows how to install one bushing. The procedure for the remaining RDU
bushing is identical.
-
Make sure the alignment marks on the RDU 204-616 /2 are aligned with the anti-rotation tabs on the RDU bushing.
Install the RDU bushing into the RDU 204-616 /2.
2. NOTE: Make sure the alignment marks are properly aligned on both RDU 204-616 /1 and RDU 204-616 /2 and the anti-rotation tabs are
properly seated in the RDU 204-616.
Install the RDU 204-616 /2 onto the RDU bushing.
3. NOTE:
-
Make sure the arrow on the RDU 204-616 /2 is visible on the bottom and facing away from the subframe. The arrow must remain straight so
that the bushings are correctly indexed into the subframe.
-
When installing the RDU bushing, RDU 204-618 /2 will fall away as the RDU bushing is installed into the subframe. The RDU 204-616 /2
does not control the depth of the bushing. The RDU bushing is fully seated when the RDU 204-616 /2 falls away from the subframe, do not
continue to tighten the RDU 204-616.
Install the RDU bushing into the subframe.
4. Install the RDU.
