Explorer FWD L4-2.0L Turbo (2011)
Installation
1. NOTE:
-
There are 2 RDU rear bushings in the rear subframe. This procedure shows how to install one bushing. The procedure for the remaining RDU
bushing is identical.
-
Make sure the alignment marks on the RDU 204-616 /2 are aligned with the anti-rotation tabs on the RDU bushing.
Install the RDU bushing into the RDU 204-616.
2. NOTE: Make sure the alignment marks are properly aligned on both the RDU 204-616 /1 and RDU 204-616 /2 and the anti-rotation tabs are
properly seated in the RDU 204- 616.
Install the RDU 204-616 onto the RDU bushing.
3. NOTE:
-
Make sure the arrow on the RDU 204-616 /2 is visable on the bottom and is facing away from the subframe. The arrow must remain straight so
the bushings are correctly indexed into the subframe.
-
When installing the RDU bushing, RDU 204-616 /2 will fall away as the RDU bushing is installed into the subframe.The RDU 204-616 does
not control the depth of the bushing. The RDU bushing is fully seated when the RDU 204-616 /3 and RDU 204-616 /1 fall away from the
subframe, do not continue to tighten the RDU 204-616.
Install the RDU bushing into the subframe.
4. Install the RDU.
