Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
NOTE: Be sure the bell crank of the liftgate latch remote control is in the unlocked position (upward) for correct lock cylinder rod length.
14. Connect the liftgate release handle actuating rod.
1
Position the liftgate release handle actuating rod.
2
Close the clip.
NOTE: Make sure the liftgate release handle actuating rod is not preloading the liftgate latch remote control. It should be clipped in a relaxed
state with no slack.
15. Connect the liftgate latch release rods.
1
Position the liftgate latch release rods by pushing outboard to remove the slack.
2
Close the clips.
NOTE: Make sure the latch release rods are not preloading the liftgate latch. They should be clipped in a relaxed state with no slack.
16. Install the watershield.
17. Install the air escape vent panel.
1
Position the air escape vent panel.
2
Install the pin-type retainers.
18. Install the liftgate trim panel.
19. Connect the battery ground cable.
