Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
5. Install the rear side shield screw.
6. Install the lumbar support knob.
7. Position the driver seat into the vehicle. Install the four seat track to floor bolts and hand-tighten them.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
8. Remove the restraint system diagnostic tool from the driver seat side air bag floor electrical connector.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
