Explorer Sport 4WD V6-245 4.0L SOHC VIN K SFI (2001)
3
Tie-strap the wire harness.
6. Connect the battery ground cable.
7. Position the driver seat rearward.
8. With the restraint system diagnostic tools still in place at the remaining deployable devices, prove out the air bag system.
9. Tighten the driver seat front track to floor bolts in the sequence shown.
1
Tighten the front inboard bolt.
2
Tighten the front outboard bolt.
10. Move and tilt the driver seat to its highest and most forward position.
11. Tighten the driver seat rear track to floor bolts in the sequence shown.
1
Tighten the rear inboard bolt.
2
Tighten the rear outboard bolt.
12. Install the driver seat rear track bolt covers.
